Into the Beam Room

Hello,

 
Starting again on Monday and getting into the week with Beamtime. After gaining a diffraction pattern of the last YBCO I made, the morning was spent attaching the capillary furnace, known as the STOIE, in the beamline; you can see pictures of it to the left. This allows the capillary to be heated more accurately and uniformly than the alternative, the hot air blower, meaning we can get nice diffraction patterns of the YBCO salts heating up.

In principle. After a few coding problems, the furnace started glowing at lower temperatures than expected and the whole experiment switched off early as a safety measure. Turned out, the thermocouple inside was rather damaged, so had to be replaced. Meanwhile, I loaded a capillary of platinum (approx. £10 worth before anyone gets too excited) to use as an alignment help later.

Once working, we started aligning a new salt capillary. This one though provided us with a few difficulties and it was while swapping it for another that I accidentally broke a capillary. Whilst becoming a rarer occurrence, I'm pleased to say, this time it did get stuck in the furnace. In the end, we switch stages (the type of stand in front of the beam) and did 'Rapid Access'; these are samples sent in just for a quick scan.

The STOIE surrounded by the giant detectors.

With the upcoming beamtime over the weekend, on Tuesday I started researching a Plan B for the time then. As a scientist, you must always be prepared for not getting what you expected, because half the time, you're trying something which may not work. For this, I was researching reactions and compounds using the Oxides I'm using for the synthesis (Barium Carbonate, Yttrium Oxide and Copper (II) Oxide).

However, there was a break as I went to a skills session of presentations. It is always useful to be able to talk other people through the work you are doing to encourage interest and further research in the subject.

The gas cell capillary enables gases to flow across the sample in situ.

Wednesday got very cold first thing, as I tried to get a train to levitate with the superconductors attached. Trying several ways and butchering it with pliers, I did get slight lift off the rear of the engine briefly, but the liquid nitrogen poured off almost as fast as it was added.

In the afternoon, I practiced preparing a gas cell capillary. This involves wrapping the sample up in quartz wool and sliding it into an open-ended tube held in a stand as shown. Whilst I didn't break many blank capillaries while practicing loading them into the stand, it turns out the putting cotton-wool-like material is harder than it looks (and it looks hard). However, I didn't break anything while doing it, so tomorrow morning, I should be able to go back and try again.

Type soon.